Gas turbine test parameters corrections including operation with water injection

Mathioudakis, K

dc.contributor.author	Mathioudakis, K	en
dc.date.accessioned	2014-03-01T01:20:33Z
dc.date.available	2014-03-01T01:20:33Z
dc.date.issued	2004	en
dc.identifier.issn	0742-4795	en
dc.identifier.uri	https://dspace.lib.ntua.gr/xmlui/handle/123456789/15956
dc.subject	Gas Turbine	en
dc.subject.classification	Engineering, Mechanical	en
dc.subject.other	Efficiency	en
dc.subject.other	Error correction	en
dc.subject.other	Flow patterns	en
dc.subject.other	Performance	en
dc.subject.other	Power converters	en
dc.subject.other	Temperature	en
dc.subject.other	Test facilities	en
dc.subject.other	Water injection	en
dc.subject.other	Acceptance testing	en
dc.subject.other	Correction curve	en
dc.subject.other	Mass flow rate	en
dc.subject.other	Specific operating point	en
dc.subject.other	Test parameters correction	en
dc.subject.other	Gas turbines	en
dc.subject.other	gas turbine	en
dc.subject.other	testing method	en
dc.subject.other	water injection	en
dc.title	Gas turbine test parameters corrections including operation with water injection	en
heal.type	journalArticle	en
heal.identifier.primary	10.1115/1.1691443	en
heal.identifier.secondary	http://dx.doi.org/10.1115/1.1691443	en
heal.language	English	en
heal.publicationDate	2004	en
heal.abstract	Methods for correcting data from gas turbine acceptance testing are discussed, focusing on matters which are not sufficiently covered by existing standards. First a brief outline is presented of the reasoning on which correction curves are based. Typical performance correction curves are shown together with the method of calculating mass flow rate and turbine inlet temperature from test data. A procedure for verifying guarantee data at a specific operating point is then given. Operation with water injection is then considered. Ways of correcting performance data are proposed, and the reasoning of following such a procedure is discussed. Corrections for water amount as well as power and efficiency are discussed. Data from actual gas turbine testing are used to demonstrate how the proposed procedure can be applied in actual cases of acceptance testing.	en
heal.publisher	ASME-AMER SOC MECHANICAL ENG	en
heal.journalName	Journal of Engineering for Gas Turbines and Power	en
dc.identifier.doi	10.1115/1.1691443	en
dc.identifier.isi	ISI:000222192700018	en
dc.identifier.volume	126	en
dc.identifier.issue	2	en
dc.identifier.spage	334	en
dc.identifier.epage	341	en